AGFA CP 1000 TABLETOP PROCESSOR
Designed and built with the same reliability as Agfa's large, high-volume
processors, the CP 1000 Processor is ideal for diagnostic clinics, remote departments,
chiropractic and veterinary offices. The CP1000 continues our product evolution by
replacing our popular line of CURIX 60 and CP60 processors and is also an excellent backup
for your regular processor.
The CP 1000 provides consistent, high-quality processing of film sizes ranging from 4" x 4" up to 14" W x 36" L for applications with moderate patient film volume.
Fast Processing
125-second cycle time (leading edge into developer to leading edge at dryer) for quick access to finished radiographers.
Energy Efficient
The CP 1000 operates on only 400 watts of power. Economical stand-by mode reduces power to 100 watts when process is idle. To further reduce power consumption, the processor may be turned off when not in active user, and quickly restarted because of its fast warm-up time.
Advantages Over Typical Low-Volume Processors
The typical processing cycle for low-volume processors is 2.5 to 3 minutes, and you must remain in the darkroom until the film has completely entered the processor, which can take over a minute. The exclusive CP 1000 Feed Tray/Light Cover allows you to leave the darkroom in about 15 seconds.
Most processors require water, drain plumbing and external replenishment. They consume 16 to 30 gallons of water per hour. The CP 1000 requires no external plumbing, and the wash-water is supplied from its 5-liter (1.3 gallon) dispenser bottle.)
Only .25 gallon of chemical is required to fill the CP 1000 Processor tanks, and they are replenished automatically. Where other processors typically require 5-gallon mixers to keep their tanks full, the CP 1000 uses premeasured concentrates that make the right amount of developer and fixer to fill the 5-liter dispenser bottles. With the CP 1000 you mix and use less chemistry and it is always fresh.
Easy to Set Up
Does not require costly professional installation and plumbing. The average time for setting up and installing the CP 1000 takes less than one hour and requires only simple tools. Call for details.
